Yukon-trail Navigator SF24 Assembly Manual Manuel d'utilisateur

1) Carefully open the carton remove the foam packaging material, then remove the bike and accessories.

2) Attach Front tire assembly to the front fork, adjust the front fork and front wheel, install the nuts, then use the wrench to tight the nuts,

3) Front fender assembly: install the front fender on front forks. Position the fender to the Tire, tighten the screws as shown below.

4) Handle Bar assembly：insert the stem into the front fork as shown below, adjust the height of the stem, adjust the direction to make

5) Seat post assembly：release the “quick release assembly”, insert seat post into the frame, adjust to desired height, then tigh

6) Pedal assembly：insert and tighten the right and left pedal onto the cranks arm.(note the rotation and the left and right pedals which are Mark

7) Front V-brake: Insert brake cable sleeve into the slot as shown, note the front wheel should rotate freely and the brake pads should not be t

8) Recheck assembly to ensure all nuts are properly tightened before use.